Return to the BUILD

“Add details to a large piece of battle section hull plating in this short but essential stage.”

NOTE: I will be presenting TWO different paths to build this Enterprise D partwork model. This is because after Stage 58, I completely tore my own model down and started on my Model Remodel journey. However, I have access to a second Enterprise D partwork that is being built in stock form, so I can show both methods here.

• The normal BUILD section below will show the ‘stock’ way of installing the parts with any tips and tricks I find along the way.
• The new MODEL REMODEL section will describe the changes I made during this stage including any painting, lighting, electronics, wiring, etc.

Contents

Parts

Materials: The Transporter Emitter Pads are metal and the Nacelle Bracket Upper Panel is plastic.

Build

Fitting the Transporter Emitter Pads

Step A

Remove the backing paper from the two Transporter Emitter Pads and stick them into these matching recesses of the Nacelle Bracket Upper Panel, as shown:

Model Remodel

There were no modifications to the parts in this stage.

Thoughts

This is a nice big piece of exterior decking! It is already pre-printed with the Enterprise and NCC-1701-D details.

Next Up

Stage 70 – Deck Panel L3-11, Outer Frame L4-10, Escape Pod Covers, Reflector, Battle Section Rear, Supply Ports