Return to the BUILD

“Assemble a further section of the lower saucer and link it to the dorsal section at the outer rim.

NOTE: I will be presenting TWO different paths to build this Enterprise D partwork model. This is because after Stage 58, I completely tore my own model down and started on my Model Remodel journey. However, I have access to a second Enterprise D partwork that is being built in stock form, so I can show both methods here.

  • The normal BUILD section below will show the ‘stock’ way of installing the parts with any tips and tricks I find along the way.
  • The new MODEL REMODEL section will describe the changes I made during this stage including any painting, lighting, electronics, wiring, etc.



Materials: The Deck Panel L3-07 is metal and the rest of the parts in this stage are plastic.

Magazine – Issue 20

  • Assembly Instructions: Building the Model
  • Episode Guide 4.20: Qpid
  • Episode Guide 4.21: The Drumhead
  • Episode Guide 4.22: Half A Life
  • Episode Guide 4.23: The Host
  • Episode Guide 4.24: The Mind’s Eye
  • Episode Guide 4.25: In Theory
  • Episode Guide 4.26: Redemption


Assembling Deck Panel L3-07

Step A

Carefully remove eleven (10) Escape Pod Covers from their sprues and fit them into the back of Deck Panel L3-07, as shown.

As in Stage 61 with these outer lower panels, I shaved off the two tiny bumps on the top and bottom with my hobby knife. This allows them to seat a bit deeper and more uniformly. While not shown here, I still recommend using pieces of black electrical tape or aluminum tape to seal in these Escape Pod Cover to prevent light leak:

Fit the Reflector Panel L3-06-07 to the back of Deck Panel L3-07 as shown, then secure the Reflector into place with two (2) AM screws.

This is your friendly reminder to try using 3-in-One Oil on all screws going into metal:

Fit the Outer Frame L4-06 to Deck Panel L3-07 aligning the pins and posts to the matching holes as shown, then secure it into place with two (2) IM screws:

Fitting Deck Panel L3-07

Step B

Retrieve your Saucer assembly from the previous stage and place it upside down on a soft surface. Fit this Deck Panel L3-07 assembly to the Lower Skeleton, as shown:

As before, there is a groove along the inside of the Outer Panel that needs to ‘pop’ onto the rim of the matching upper Deck Panel here:

Secure this Deck Panel to the Lower Skeleton with two (2) FM screws, as shown:

If this Panel fitment is satisfactory, press the two pins of the Escape Pod Screw Cover into the matching holes at this location of the Panel.

This Screw Cover should be installed so the red line is closer to the edge of the saucer. However, you may want to wait until you are happy with the fitment of all of the lower saucer panels before hiding these screws. It may be difficult to remove these Screw Covers once installed:

That step ends this stage of the stock build. Below you will find the details on what I changed in this stage as part of my Model Remodel.

Model Remodel

Fitting Deck Panel L3-07

  • The Escape Pod Covers were sealed in from behind with aluminum tape
  • As with my other Outer Panels, this one was again sealed at the outer edges with adhesive putty

Here is the result of our Model Remodel changes in this stage:


Nothing unusual in this stage, just another outer deck panel on the lower saucer! Keep the Battle Section Front Panel nearby as it will needed in the next stage.

Next Up

Stage 76 – Lower Skeleton 6, Battle Section Front Windows Left, LED Brackets, Lights

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.